Westinghouse WSF6602 - Manual (Page 11)

SETTING AND STARTING A WASHING PROGRAM
STARTING THE WASHING PROGRAM
WITHOUT DELAY START
1. Close the appliance door.
2. Switch on the appliance. Make sure that
the appliance is in setting mode.
3. Set a washing program. Refer to 'Wash-
ing programs'.
• The related program indicator comes
on.
• All other program indicators go off.
• The time of the program flashes in the
display.
• The START indicator flashes.
4. Press the START button. The washing
program starts.
• The time of the program is no longer
flashing in the display.
• The START indicator is no longer
flashing.
STARTING THE WASHING PROGRAM
WITH DELAY START
1. Close the appliance door.
2. Switch on the appliance. Make sure that
the appliance is in setting mode.
3. Set a washing program.
4. Press the DELAY button repeatedly until
the display shows the time you want to
set for the delay start.
• The time of the delay start flashes in
the display.
5. Press the START button. The count-
down starts.
When the countdown is completed, the
washing program starts automatically.
The opening of the appliance door in-
terrupts the countdown. When you
close the door, the countdown contin-
ues from the point of interruption.
CANCELLING THE DELAY START
If you have not yet pressed the START
button
1. Press the DELAY button repeatedly until
the display shows the time of the wash-
ing program.
2. Press the START button, the washing
program starts.
If the START button has been pressed
and the countdown operates
• Press the DELAY button repeatedly until
the display shows the time of the wash-
ing program. After a few seconds the
washing program starts automatically.
Warning! Only interrupt or cancel a
washing program if necessary.
Attention! Open the door carefully.
Hot steam and water can escape.
INTERRUPTING A WASHING
PROGRAM
• Open the appliance door. The washing
program stops.
• Close the appliance door. The washing
program continues from the point of in-
terruption.
CANCELLING THE WASHING
PROGRAM
If you have not yet pressed the START but-
ton, you can change the setting.
To change the setting while the washing
program operates, it is necessary to cancel
the program.
• Press and hold the PROGRAM button
and the DELAY button at the same time
until all the program indicators come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new washing program.
END OF THE WASHING PROGRAM
When the washing program is completed,
the display shows 0.
1. Switch off the appliance.
2. Open the appliance door.
For better drying results, keep the ap-
pliance door ajar for some minutes.
REMOVING THE LOAD
• Let the dishes cool down before you re-
move them from the appliance. Hot
dishes are easily damaged.
• First remove items from the lower basket,
then from the upper basket.
westinghouse 11