MAXWELL MW-3011 G - Manual (Page 10)

10
ENGLISH
Note: While steam ironing set the tem-
perature “•••” or MAX.
WATER SPRAYER
• You can dampen the fabric by pressing
the spray button (4) several times.
• Make sure that there is enough water in
the water tank (10).
IRONING
• Place the iron on the base (8).
• Insert the power plug into the outlet
.
• Set the temperature regulator (11) to the
required ironing temperature
: “•”, “••”,
“•••”or “MAX” ( depending on the type
of fabric ), the (9) indicator will light up.
• When the sole temperature (13) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
• After you finish ironing set the (11) regu-
lator to the “MIN” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
For steam ironing set the temperature
regulator to steam using zone or “•••” or
MAX.
• Place the iron on the base (8).
• Insert the power plug into the outlet
.
• Make sure that there is enough water in
the water tank (10).
• Set the temperature regulator (11) to the
required ironing temperature
: to steam
using zone or “•••” or MAX ( depending
on the type of fabric ), the (9) indicator
will light up.
• When the sole temperature (13) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
• Switch on the constant steam supply,
setting the switch (3) in vertical position,
steam will start outgoing from the open-
ings of the sole
(13).
• After you finish ironing set the (11) regula-
tor to the “MIN” position and the steam
supply regulator (3) to the off position.
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not con-
stantly supplied, check whether the tem-
perature regulator (11) is set properly and
whether there is water in the reservoir.
ADDITIONAL STEAM RELEASE
Additional steam release function is useful
when ironing folds and can only be used at
high ironing temperatures (when the iron
temperature regulator (11) is set to
“•••”
or MAX ).
• When the additional steam release but-
ton (5) is pressed, steam will be vigor-
ously released from the openings in the
iron sole.
Note: In order to avoid leakage of water
from steam openings, press the addi-
tional steam supply button (5) with 45
sec. interval.
VERTICAL STEAMING
For vertical steaming can be used only
when the high temperature mode is used
(set the temperature regulator (11) to
«•••» or MAX).
•
Hold the iron vertically at the distance
15-30 cm from the clothes press the ad-
ditional steam release button (5) with 4-5
seconds interval, steam will be released
from the openings in the iron sole (13).
Important information
• Vertical steaming is not recommended
for synthetic fabrics.
• To avoid melting the fabric, do not touch
the iron sole to the item while steaming.
• Never steam iron clothing that is being
worn as the steam temperature is very
high and it can cause burns. Use a coat-
hanger or a stand.
STEAM CHAMBER CLEANING
To prolong lifetime of the iron we recom-
mend cleaning the steam chamber, espe-
cially in the regions with “hard” water.
•
Set the steam supply regulator (3) to the
off position.
• Fill the water tank (10) till the MAX mark
(12).
MW-3011.indd 10 MW-3011.indd 10 11.02.2010 16:27:14 11.02.2010 16:27:14