weber 1200 - Manual (Page 31)

31
e) Remove the manifold bracket and unscrew the two
wing nuts that hold the manifold to the cooking box.
Pull the manifold and valve assembly out of the
burners and carefully set it down. Figure 14.
f) Slide the burner assembly out from under the guide
screw and washer in the corners of the cooking box.
Figure 15.
View from behind
cooking box
Wing nuts
Figure 14
g) Lift and twist the burner assembly slightly, to separate
the crossover tube from the burners. Figure 16.
Remove the burners from the cooking box.
Guide screw
Figure 15
Crossover tube
Figure 16
Figure 13
d) Unlatch the Spider Stopper Guards and remove.
Figure 13.
h) To reinstall the burners, reverse steps c) through g).
ƽ CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 17a.
Check proper assembly before fastening manifold in place.
Figure 17b.
Figure 17
Valve
Burner
(a)
(b)