Westinghouse WHDBI-5C - Manual (Page 12)

10
CHANGING A CONSOLE’S SETTINGS
214601 C - IMAGE 12
3
1
2
THE FACTORY SETTING FOR THE FREQUENCY
SWITCH IS "A", SET THE FREQUENCY SWITCHES
TO MATCH ON ALL CONSOLES (ALL EITHER "A" OR "B")
1. START WITH THE POWER OFF (VOLUME KNOB OFF)
2. PRESS & HOLD DOWN "ALL CALL" & "TALK" BUTTONS
3. TURN POWER ON (TURN VOLUME KNOB ON HALFWAY)
4. WHEN ALL STATION LIGHTS FLASH, RELEASE THE BUTTONS
TO CHANGE A CONSOLE OR
ADD A NEW CONSOLE,
PREPARE THE CONSOLE
FOR PROGRAMMING
1. PRESS A NUMBER BUTTON TO SET THE CONSOLE'S
STATION NUMBER (SELECT A DIFFERENT STATION
NUMBER FOR EACH CONSOLE)
2. THE SELECTED STATION NUMBER INDICATOR
WILL FLASH
1. PRESS AND RELEASE THE TALK BUTTON
2. THE CONSOLE WILL BEEP, COUNTING THE
EXISTING HOUSE CODE NUMBER
1. PRESS THE ALL CALL BUTTON 1 TO 15 TIMES
TO SET THE NEW HOUSE CODE NUMBER
2. THE CONSOLE WILL BEEP, COUNTING THE NEW
HOUSE CODE NUMBER
3. PRESS THE TALK BUTTON TO EXIT PROGRAM MODE
SET THE CONSOLE'S STATION NUMBER
SET THE CONSOLE'S NEW HOUSE CODE NUMBER
NOTE: UNITS ARE PRE-SET AT THE FACTORY
WITH THE SAME HOUSE CODE, CHANGING
THE HOUSE CODE IS ONLY NECESSARY
WHEN ADDING ADDITIONAL UNITS OR TO
AVOID OVERLAP WITH OTHER SYSTEMS
SET THE MUTE SWITCH TO
OFF WHILE PROGRAMMING
NOTE: ALL UNITS MUST BE SET TO
THE SAME HOUSE CODE NUMBER
TALK BUTTON MAKES
THE CONSOLE SOUND
THE EXISTING HOUSE
CODE NUMBER
ALL CALL BUTTON
ENTERS THE NEW
HOUSE CODE
NUMBER
SETTING THE
CONSOLE'S
STATION
NUMBER
FACTORY SETTING:
HOUSE CODE = 10
NOTE: TO EXIT PROGRAMMING WITHOUT
CHANGING THE HOUSE CODE NUMBER,
PRESS THE TALK BUTTON TWICE