Weider Pro 2250 - Manual (Page 7)

7
6. Press two 1” x 7/8” Plastic Bushings (75) onto the
welded spacers on the Press Frame (17). Slide
the Press Frame into place on the Base (4) as
shown. Note: This will be a tight fit. The Plastic
Bushings should fit onto each end of the indi-
cated tube in the Base.
Lubricate the 3/8” x 8” Bolt (59) with grease.
Attach the Press Frame (17) to the Base (4) with
the Bolt and a 3/8” Nylon Locknut (21). Do not
overtighten the Locknut; the Press Frame
must be able to pivot easily.
7
4
5
6
60
8
8
11
3
3
55
62
42
44
44
78 55
27
27
75
21
59
22
22
17
21
46
33
49
73
17
Tube
Lubricate
Welded
Spacer
4
Arm Assembly
7. Press a 2” Round Inner Cap (33) into the top of
the Right Press Arm (46). Press two 1” Round
Inner Caps (49) into the handle on the Press Arm.
Attach the Right Press Arm (46) to the indicated
side of the Press Frame (17) with two 3/8” x
2 3/4” Bolts (22) and two 3/8” Nylon Locknuts
(21).
Assemble the other Press Arm (73) in the
same manner.
4. Press two 2” Square Inner Caps (27) into the indi-
cated ends of the Top Frame (55). Press two
1 3/4” Square Inner Caps (44) into the ends of
the crossbar on the Top Frame. Press two Round
Inner Caps (78) into the top of the crossbar.
5. Attach the Top Frame (55) to the Front Upright
(42) with two 5/16” x 2 3/4” Bolts (11), two 5/16”
Washers (8), and two 5/16” Nylon Locknuts (3).
Attach the upper ends of the Weight Guides (62)
to the Top Frame (55) with a 5/16” x 6” Bolt (60)
and a 5/16” Nylon Locknut (3).
Tighten the 5/16” Nylon Locknuts (3) used in
steps 2 and 5.
Crossbar