Weider PRO 125 - Manual (Page 8)

8
9
10
8. Attach a 30mm x 25mm Bumper (26) to the indicated
hole in the Main Frame (1) with a Bumper Screw (25).
Press a 25mm x 50mm Inner Cap (14) into each end
of the Seat Frame (5).
Important: The Seat Frame (5) has two welded
tubes. ÒTube AÓ goes through the Seat Frame
itself, and ÒTube BÓ is welded underneath the
Seat Frame. Do not confuse these two tubes in
the following step.
Line up Tube A in the Seat Frame with the upper hole
in the bracket on the Main Frame (1). Insert the M10
x 95mm Bolt (20) through the bracket and the welded
tube in the Seat Frame. Secure the Bolt with an M10
Nylon Locknut (18).
Note: The Locking Pin w/Ring can be inserted
through Tube B to prevent the Seat Frame (5) from
pivoting.
9. Attach the Seat (9) to the brackets on the Seat Frame
(5) with four M6 x 16mm Screws (15).
10. Press a 19mm Round Inner Cap (13) into each end of
the Short Pad Tube (31) and the Long Pad Tube (12).
Mount the Long Pad Tube (12) in the hole in the Seat
Frame (5) in the following manner: Slide a Plastic
Spacer (30) and a Foam Pad (11) onto one end of the
Pad Tube. Slide the Pad Tube through the hole in the
Seat Frame. Slide a Plastic Spacer (30) and a Foam
Pad (11) onto the other end of the Pad Tube.
Mount the Short Pad Tube (31) in the hole in the
sidearm on the Leg (6) by following the instructions
given above.
30
1
14
25
26
14
5
9
20
8
31
3
6
11
11
3
3
3
5
13
12
13
Welded Tube (A)
Welded
Tube (B)
Bracket
15
15
15
15
18
5