Wolfgang Puck BRGG0090 - Manual (Page 5)

7 8
Using Your Electric
Grill / Griddle
Place the appliance on a flat, level surface, such as a countertop or table.
Place the cooking surface onto the base with either the grill or griddle
surface up, according to your recipe.
Insert power point into the power point holder on the grill/griddle plate.
Plug the cord into a 120 volt 60 Hz AC only outlet.
When the grill/griddle is on, the red READY light will come on. This light
is in the shape of an arrow, located on the power point. When the light
goes out, the grill or griddle surface is preheated to the selected
temperature. This light will cycle on and off during cooking, indicating
that the surface temperature is being maintained.
Important: Your grill/griddle comes with a patented safety feature which
will not allow you to plug the temperature probe in unless the drp pan is
properly in place. Never Try To Defeat This Feature.
Using Your Reversible Grill/Griddle with Splash Guard
1 Assemble the Splash Guard Accessory
by inserting both side panels to the back panel
(see Figures 1 and 2).
2 Place the Splash Guard directly on
the top of your Reversible Grill/Griddle plate
(See figure 3).The side panels should be placed
between the side handles and grill plate while
the back panele gently sits on the edge of the
grill plate.
Care and Cleaning
Before cleaning, be sure to unplug the cord from the outlet. Remove the
power point from the cooking surface. If necessary, wipe the cord with a
damp cloth.
Caution: Do not immerse the cord in water or other liquid.
Allow the appliance to cool completely before cleaning.The cooking
plate and base can be placed in the bottom rack of the dishwasher, or
washed by hand. The drip tray should be hand washed only in warm
soapy water. Dry the drip pan completety when finished.Do not put hot
cooking surface in cold water.
Be sure to always wash both the grill and griddle surfaces after each use
to remove any grease that may have accumulated.
Do not use scouring pads or harsh cleaners on either the cooking
surface or base. If necessary, use a nylon bristle brush or plastic
scrubbing pad.
Do not let the cooking surface or base soak overnight. This could
damage the nonstick coating.
Figure 1
Figure 2
Figure 3
HSN_RGG_090C 2/4/10 1:00 PM Page 7