weber 55768 - Manual (Page 21)

C-2
Gas Instructions
Remove control panel and burner control knobs
You will need: Phillips screwdriver.
1) Remove control knobs.
2) Unhook side burner from Cookbox Frame.
3) Remove screws with a Phillips screwdriver
4) Pull up igniter button until it sticks in the up position
and remove control panel from grill.
5) Replace control panel when Leak Check is completed.
(3)
(4)
(1)
(2)
Check that all burner valves are off
Valves are shipped in the OFF position, but you should
check to be sure that they are turned OFF. Check by
pushing down and turning clockwise. If they do not turn,
they are off. Proceed to the next step. If they do turn
continue turning them clockwise until they stop, then they
are off. Proceed to the next step.
Check the flexible hose to manifold connection
See Page C-3
The Natural gas hose has been attached during the
manufacturing process. We do recommend that the hose
to gas manifold connection be leak tested, following
guidelines in this Owners Guide, prior to barbecue
operation.
Check:
1) Hose to manifold connection.
ƽ WARNING: If there is a leak a connection(1),
retighten the fitting with a wrench and recheck for
leaks with soap and water solution.
If a leak persists after retightening the fitting, turn OFF
the gas. DO NOT OPERATE THE GRILL. Contact the
Customer Service Representative in your region using
the contact information sheet provided with your
manual.
(1)