Wachsmuth & Krogmann Item# 7256 - Manual (Page 9)

Slide the vacuum cleaner onto the charging station. Be sure that
it is seated all the way in (see FIG. 6).
FIG. 6
By connecting the vacuum cleaner to the power source, the charging process will begin.
The red light on the unit will indicate that the vacuum cleaner is in the charging process.
As long as the vacuum cleaner is connected to a power source the red light will
stay on. If the vacuum cleaner is used daily it can be left in the charging station. If the
unit is not used for an extended period or not frequently used it is recommended to
remove the unit from the charging station and unplug it from the power source.
If rechargeable battery of the hand vacuum cleaner is not fully discharged, it usually can
be recharged within 3 hours to reach the maximum capacity. During the charging
process the unit may get slightly warm which is normal.
To extend the life time of this appliance always recharge after every use. NEVER FULLY
DISCHARGE THE BATTERY.
For replacement rechargeable batteries see attached order form.
CAUTION: NEVER use the unit without the battery compartment cover in place.
MAINTENANCE
CAUTION:
Always be sure that the appliance is switched OFF before cleaning the appliance or
attempting to store the item.
CLEANING THE DUST CUP AND FILTER
1. Remove the dust cup container by pressing the button on the top of the unit.
2. Remove by pulling the dust cup forward, away from the unit.
3. Empty the dust cup from the dust cup container.
4. Rinse the dust cup filter in cold water, and then wait until it dries completely
before replacing it back into the dust cup container. DO NOT use a washing
machine to clean the dust cup filter. DO NOT use a hair dryer to dry filter. AIR
DRY ONLY.
5. Replace the dust cup filter carefully into the dust cup compartment. NEVER
operate hand vacuum without dust cup filter in place.
6. Attach the dust cup container to the cordless vacuum.
7. The housing of the unit can be cleaned with a damp cloth and mild detergent.
8. Do not use abrasive powders, hard abrasive scourer or steel wool.
IMPORTANT: Make sure that the Dust Cup Filter is completely air dried before
re-installing back into the hand vacuum.
NOTE: It is recommended that the dust cup filter be replaced every three
months to ensure peak performance of unit. See attached order form.
8