beautypg.com

8installation instructions – Vista VPC9030 User Manual

Page 8

background image

8

Installation Instructions

LENS SELECTION

Suitable lens types are C and CS mount in fixed iris, manual iris, auto iris or direct drive versions.

Sizes are shown below. Cameras are factory set for CS mount lenses. If using a C mount lens,

rotate either of the back focus screws approximately 30 turns anticlockwise before fitting the

lens.

Lens size

1/3"

1/2"

2/3"

1"

V

P

M

8

0

3

0

V

P

M

8

1

2

0

V

P

C

9

1

3

0

V

P

M

8

0

3

2

V

P

M

8

1

2

2

V

P

C

9

1

3

2

V

P

C

9

0

3

2

/C

M

V

P

C

9

1

3

2

/C

M

V

P

M

8

1

3

0

V

P

C

9

0

3

0

V

P

M

8

1

3

2

V

P

C

9

0

3

2

LENS SETUP PROCEDURES

For manual or fixed iris lenses set the EI switch to ON.
Auto Iris Lenses

Switch the EI off. Refer to the lens instructions and adjust the lens for the optimum picture

(video output level of 1V peak-to-peak).
Direct Drive Lenses

Switch the EI off. Use an appropriate screwdriver to turn the lens level potentiometer (under

the hinged flap) fully clockwise then back off until the optimum picture is obtained (video output

level of 1V peak-to-peak).

FOCUS ADJUSTMENT

The back focus adjustment screws are located on the top and side of the case and should be

adjusted using an appropriate screwdriver. If possible, always use the top screw to adjust the

back focus mechanism.
Turn the adjuster screw clockwise or anticlockwise to obtain focus. When the focus is sharp,

turn the back focus adjustment screw 2 or 3 turns anticlockwise. The picture will lose sharpness.

Turn the back focus screw clockwise until focus is once again obtained. If you have turned the

back focus screw clockwise past the point of best focus, repeat the procedure. The last turn

of the back focus adjustment screw must always be in a clockwise direction. Do not

‘over turn’ the back focus mechanism.
Fixed Lenses

Set the lens focus to infinity and view an image greater than two meters away. Focus the image

using the back focus screw. Set the lens focus as required.
Manual Iris Lenses

Open the iris fully and set the lens focus to infinity. View an image greater than 7 feet (2 meters)

away. Focus the image using the back focus screw. Set the lens focus and iris as required.

This manual is related to the following products: