VTech DS221-2 - Manual (Page 8)

4
Getting started
Installation options
Your telephone base is ready for tabletop use. If you want to mount your If you want to mount your
telephone on a wall, use the provided wall bracket to connect with a standard
dual-stud telephone wall mounting plate. If you do not have this mounting
plate, you can purchase one from many hardware or consumer electronics
retailers. You might need a professional to install the mounting plate.
Tabletop to wall mount installation
Position the telephone base as shown below. Insert the extended tabs
(marked B) of the wall bracket into the slots on the back of the telephone
base (marked B). Push the telephone base down until it is securely in place.
If you are using a DSL filter, plug the line cord into the filter now. Route the
telephone line cord (or DSL filter) through the wall bracket hole. Route the
power cord out of the bottom of the telephone.
Plug the telephone line cord (or DSL filter) into the wall jack. Plug the
power adapter into a power outlet not controlled by a wall switch.
Align the holes on the bracket with the standard wall plate and slide the
bracket down until it locks securely. Bundle the telephone line cord and
power adapter cord neatly with a twist tie.
1.
2.
3.
4.
1 2
3 4