Velodyne Acoustics SPLI SERIES SPL-1000I - Manual (Page 8)

Figure 1. Installation Using LFE Line-Level Inputs
Note: If not using an external crossover, you should use the built-in crossover for
optimal performance. When using a single channel input (such as a surround sound
processor’s subwoofer out or LFE), the auto on/off circuit sensitivity will be affected.
When one input channel is used instead of two, the unit will see lower signal levels
present at the inputs. This may cause the unit to turn off when listening at low volume
levels. If this occurs, simply use a “Y” adapter (available from most dealers) to allow
your processor’s single sub line to be fed into both L&R inputs. This will make the unit
turn on at lower signal levels.
5
.
w w w . v e l o d y n e . c o m
SPLi Series User’s Manual
NOTE: SPL-800i is
identical in features
and layout to the
SPL-1000i shown.