Vestax Mixing Controller - Manual (Page 7)

PGM 2 SUB PGM 1 OUTPUT EFFECT
R
R
L
L
MASTER OUT 1
R
R
L
L SEND
ON
OFF
LINE 6
R L
LINE 5
PHONO 3
R L LINE 2
LINE 1
PHONO 1
LINE 3
PHONO 2
RETURN
GND GND
MADE IN JAPAN SERIAL NO.
AC100V 50 / 60Hz 16W
PMC-27 POWER
AC 100V
MASTER OUT 2
28 30 31
34
33
35
32
29
REAR PANEL
28. POWER SWITCH
The first LED of MASTER OUT LEVEL METER
that is located on the top panel is lit when on.
29. AC POWER CABLE
30. OUTPUT JACK(1/4inch PHONE JACK, RCA PIN JACK)
Connect to the input of power amplifier.
31. EFFECT SEND JACK
Connect the SEND jacks to the input of an
external effector unit(Delay,Reverb etc)
32. EFFECT RETURN JACK
Connect the RETURN jacks to the output of the
effector.
33. PHONO INPUT JACK
Input jack for PGM1,PGM2 and SUB channel
turntables.
Connect turntables equipped with the MM pick up
certridge only.
34. LINE INPUT JACK
Input connectors for the line level equipment such
as CD players, tape decks, DATs, MDs.
35, GROUND TERMINAL
Connect this terminal to the ground lead of the
turntable. This helps to redusce noise and hum.
REAR PANEL
ISOLATOR SECTION
25, HI SWITCH
Allows cutting off the sound of treble range. Sound volume will be
cut when the switch is set downwards. When the switch is put back,
the output volume returns to normal. Can be useful for cutting off
the sound of the cymbals or high hats for example.
26, MID SWITCH
Allows cutting off the sound of the middle range. Sound volume will
be cut when the switch is downward position. When the switch is
put back, the output volume becomes normal sound volume. Can be
used for cutting off vocal and melody from the source.
27, LOW SWITCH
Allows cutting off the sound of the bass range. Sound volume will be
cut when the switch is set downward. When the switch is put back,
the output volume return to normal. Can be utilized for creating the
effects of an acapella.
PGM1 ISOLATOR
LOW MID HI
25 26 27
ISOLATOR SECTION