VOX Amplification USA VTX150 - Manual (Page 20)

20
NOTE: The effect on/off setting is independent for each program. In
Preset mode or Channel Select mode, any changes you make will be lost if
you don’t save the edited program before switching to another program
or to Manual mode, or before turning off the power.
Using a foot controller (VOX VC-12SV)
If an optional (separately sold) VOX VC-12SV foot controller is connected, the
number of user programs is increased to 16 (4 banks x 4 channels), and you’ll
be able to select banks 3 and 4 which cannot be selected from the amp itself.
HINT: For details on
how to save a
program to bank 3
or 4, please refer to
“Saving a program”
(p.16).
The VC-12SV also allows
you to control the following with your foot.
- Switch banks or channels (only in Channel Select mode)
- Use the volume pedal to control the volume
- Use the expression pedal to control parameters
- Use the foot switches to turn individual effects on/off
- Use a foot switch to activate the tuner
- Use a foot switch to set the delay time and modulation speed (the Tap
function)
NOTE: Please do not connect VTX150 Neodymium to the VOX BUS SUB
connector. Two VTX150 Neodymium units can not be controlled by the
VC-12SV.
HINT: For details on connecting and operating the VC-12SV, please refer
to the VC-12SV owner’s manual.
HINT: The VC-12SV operation when the VTX150 Neodymium is in Preset
mode is the same as when it is in Manual mode. For details on operation
in Manual mode, please refer to the VC-12SV owner’s manual.
Expression pedal setting
Each of the VTX150 Neodymium's programs assigns a function to the expres-
sion pedal, allowing you to use the expression pedal to control not only wah
but a variety of other effect parameters.
HINT: If you select AUTO WAH, the expression pedal will automatically
function as a wah pedal.