Vertex Standard Yaesu VX-2R - Manual (Page 16)

16
Alignment
TX Deviation (High Band Edge) Adjustment (dEV)
r
Press the [V/M] key.
r Inject a 1 kHz audio tone at a level of 50 mV (rms) to
the MIC jack, then press the [F/W] key.
r Transmit, and adjust the deviation for 4.2 kHz (±0.2
kHz) by rotating the DIAL knob, then press the [V/M]
key.
r Rotate the DIAL knob to select the next setting.
CTCSS Tone (67.0 Hz) Deviation (High Band Edge)
Adjustment (670)
r Press the [V/M] key.
r Transmit, and adjust the deviation for ±0.6 kHz (±0.05
kHz) by rotating the DIAL knob, then press the [V/M]
key.
r Rotate the DIAL knob to select the next setting.
CTCSS Tone (123.0 Hz) Deviation (High Band Edge)
Adjustment (123)
r Press the [V/M] key.
r Transmit, and adjust the deviation for ±0.6 kHz (±0.05
kHz) by rotating the DIAL knob, then press the [V/M]
key.
r Rotate the DIAL knob to select the next setting.
CTCSS Tone (254.1 Hz) Deviation (High Band Edge)
Adjustment (254)
r Press the [V/M] key.
r Transmit, and adjust the deviation for ±0.6 kHz (±0.05
kHz) by rotating the DIAL knob, then press the [V/M]
key.
r Rotate the DIAL knob to select the next setting.
DCS Tone Deviation (High Band Edge) Adjustment (dCS)
r
Press the [V/M] key.
r Transmit, and adjust the deviation for ±0.6 kHz (±0.05
kHz) by rotating the DIAL knob, then press the [V/M]
key.
This completes the internal alignment routine for all bands.
To save all settings and exit, press the [HM/RV] key.