Video Products ST-C51394-250 - Manual (Page 4)

INSTALLATION：
There are two FireWire Cat.5 Extenders included in the package. Both units can act as
either transceiver or receiver.
1. Connect the FireWire Cat.5 Extender to the host system with an IEEE1394 cable (with
IEEE1394b Bilingual/Beta 9 Pin Connector ).
2. Plug in the Power Adapter (9V, 0.3A) into the other FireWire Cat.5 Extender ( at
the Device Side. There is no need to plug-in any Power Adapter at the host side).
3. Connect your Cat.5e or Cat.6 cable with the attached Crossover Coupler between
these two FireWire Cat.5 Extenders ( refer to Figure 1.).
4. Connect IEEE1394 Device to the second FireWire Cat.5 Extender with an IEEE1394
cable (with IEEE1394b Bilingual/Beta 9 Pin Connector ).
5. Operate the IEEE1394 Device just like it is directly connected to the host system.
6. Check the LED in the front panel. Make sure that the LED on each extender illuminates
in solid green LED. That indicates the extenders are powered and communicating.
Crossover Coupler
Cat.5e/6 Cable
Extender Extender
( Straight Type )
Fig. 1
3