VTech 910 ADL - Manual (Page 4)

MAINTENANCE
FCC AND IC REGULATIONS
This equipment complies with Parts 15 and
68 of the Federal Communications
Commission (FCC) rules for the United
States. It also complies with regulations
RSS-210 and CS-03 of Industry Canada
(IC).
A label is located on the underside of the
base unit containing either the FCC
registration number and Ringer Equivalence
Number (REN) or the IC registration number
and Load Number. You must, upon request,
provide this information to your local
telephone company.
T h i s e q u i p m e n t i s c o m p a t i b l e w i t h
inductively coupled hearing aids.
FCC Part 15
Warning:Changes or modifications to this
unit not expressly approved by
t h e p a r t y r e s p o n s i b l e f o r
compliance could void the user's
a u t h o r i t y t o o p e r a t e t h e
equipment.
The equipment has been tested and found
to comply with part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
a n d u s e d i n a c c o r d a n c e w i t h t h e
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
t e l e v i s i o n r e c e p t i o n , w h i c h c a n b e
determined by turning the equipment off and
on, the user is encouraged to try and correct
the interference by one or more of the
following measures:
WARRANTY STATEMENT
T A K I N G C A R E O F Y O U R
TELEPHONE.
Your VTECH 910 ADL cordless
telephone contains sophisticated
electronic parts so it must be treated
with care.
Avoid rough treatment
Place the handset down gently. Save
the original packing materials to protect
your telephone if you ever need to ship
it.
Avoid Water
Your telephone can be damaged if it
gets wet. Do not use the handset
outdoors in the rain, or handle it with
wet hands. Do not install your base
unit near a sink, bathtub or shower.
Remember that electrical appliances
can cause serious injury if used when
you are wet or standing in water. If
your base unit should fall into water,
DO NOT RETRIEVE IT UNTIL YOU
UNPLUG THE POWER CORD AND
TELEPHONE LINE CORDS FROM
THE WALL
. Then pull the unit out by
the unplugged cords.
Electrical Storms
Electrical storms can sometimes cause
power surges harmful to electronic
equipment.
For your own safety, use caution when
using electric appliances during
storms.
Cleaning your telephone
Your telephone has a durable plastic
casing that should retain its luster for
many years. Clean it only with a soft
cloth slightly dampened with water or
a mild soap. Do not use excess water
or cleaning solvents of any kind.
WHAT DOES OUR WARRANTY COVER?
* Any defect in material or workmanship.
FOR HOW LONG AFTER THE ORIGINAL PURCHASE?
* One Year.
WHAT WILL VTECH DO?
* At our option, repair or replace your unit.
HOW DO I SEND MY UNIT, IN OR OUT OF WARRANTY?
* Call VTECH Communications customer service for Return Authorization at:
1-800-624-5688
* Properly pack your unit. Include any cables & accessories which were originally provided
with the product. We recommend using the original carton and packing materials.
* Include in the package a copy of the sales receipt or other evidence of date of original
purchase (if the unit was purchased within the last twelve months.)
* Print your name and address, along with a description of the defect, and include this in the
package.
* Include payment for any service or repair not covered by the warranty, as determined by
VTECH Communications.
* In the US, ship the unit via UPS Insured, or equivalent to:
VTECH COMMUNICATIONS
8770 SW NIMBUS AVENUE
BEAVERTON, OREGON 97008
VTECH Communications assumes no responsibility for units sent without prior Return Authorization.
WHAT DOES OUR WARRANTY NOT COVER?
* Batteries
* Damage from misuse, neglect, or acts of nature (lightning, floods, power surges. etc.)
* Products which may have been modified or incorporated into other products
* Products purchased outside the USA
* Products serviced by the owner or a service facility not expressly authorized by VTECH
Communications
* Products purchased more than 12 months from current date
HOW DOES STATE LAW RELATE TO THIS WARRANTY?
* This warranty gives you specific rights. You may also have other rights which vary from
state to state.
IF YOU PURCHASED YOUR TELEPHONE IN CANADA
Please call: 1-800-267-7377
Ship to: VTECH ELECTRONICS
200-7671 ALDERBRIDGE WAY
RICHMOND, BC V6X 1Z9
IC (Industry Canada)
This telephone is registered for use in
Canada.
Notice:The Industry Canada label
identifies certified equipment.
This certification means that the
e q u i p m e n t m e e t s c e r t a i n
telecommunications network,
protective, operational and
safety requirements. Industry
Canada does not guarantee the
equipment will operate to the
user’s satisfaction.
Before installing this equipment, users
should ensure that it is permissible to be
connected to the facilities of the local
t e l e c o m m u n i c a t i o n s c o m p a n y. T h e
equipment must also be installed using an
acceptable method of connections. The
c u s t o m e r s h o u l d b e a w a r e t h a t
compliance with the above conditions may
not prevent degradation of service in
situations.
Repairs to certified equipment should be
made by an authorized Canadian
maintenance facility designated by the
supplier. Any repairs or alterations made
by the user to this equipment, or
equipment malfunctions, may give the
telecommunications company cause to
request the user to disconnect the
equipment.
FCC AND IC REGULATIONS
* Reorient or relocate the receiving
antenna.
* Increase the separation between the
equipment and receiver.
* Connect the equipment into an outlet or
on a circuit different from that to which the
receiver is connected.
* Consult the dealer or an experienced
radio/TV technician for help.
FCC Part 68
The FCC requires that you connect your
cordless telephone to the nationwide
telephone network through a modular
telephone jack (USOC RJ11C or RJ11W).
Your telephone company may discontinue
your service if your equipment causes harm
to the telephone network. They will notify you
in advance of disconnection, if possible.
During notification, you will be informed of
your right to file a complaint with the FCC.
If it is determined that your telephone
equipment is malfunctioning, the FCC
requires that it not be used and that it be
unplugged from the modular jack until the
problem has been corrected. Repairs to this
telephone equipment can only be made by
the manufacturer or its authorized agents or
by others who may be authorized by the FCC.
For repair procedures, follow the instructions
outlined under the VTECH Limited Warranty.
The REN is useful in determining the number
of devices you may connect to your
telephone line and still enable the devices to
ring when you receive a call. The general rule
is that the REN value should not exceed 5.0
total; however, contact your local telephone
company for the specific number in your area.
Users should ensure for their own
protection that the electrical ground
connections of the power utility,
telephone lines and internal metallic
water pipe system, if present, are
connected together. This precaution
may be particularly important in rural
areas.
Caution:Users should not attempt to
m a k e s u c h c o n n e c t i o n s
t h e m s e l v e s , b u t s h o u l d
contact appropriate electric
i n s p e c t i o n a u t h o r i t y, o r
electrician, as appropriate.
The Load Number (LN) assigned to this
device denotes the percentage of the
total load to be connected to a telephone
loop which is used by the device to
prevent overloading. The termination on
a loop may consist of any combination
o f d e v i c e s s u b j e c t o n l y t o t h e
requirement that the total of the load
numbers of all devices does not exceed
100.
This device complies with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions: (1) this
device may not cause interference, and
(2) this device must accept any
interference, including interference that
may cause undesired operation of the
device.
TECHNICAL
SPECIFICATIONS
FREQUENCY CONTROL
Crystal Controlled Dual PLL Synthesizer
TRANSMIT FREQUENCY
Handset: 925.05 Mhz to 927.75 MHz (All
ten channels within this range)
Base: 902.3 MHz to 905.0 MHz (All ten
channels within this range)
RECEIVE FREQUENCY
Handset: 902.3 MHz to 905.0 MHz
(All ten channels within this
range)
Base: 925.05 MHz to 927.75 MHz
(All ten channels within this
range)
NOMINAL EFFECTIVE RANGE
Maximum power allowed by FCC and IC.
Actual operating range may vary according
to environmental conditions at the time of
use.
SIZE
Handset: 18.2cm x 6.2cm x 3.8cm
(L x W xT) maximum
(antenna excluded)
Base: 21.0cm x 14.2cm x 5.0cm
(L x W x T) maximum
(antenna excluded)
WEIGHT
Handset: 250 grams
Base:
415 grams
POWER REQUIREMENTS
Handset: Self-contained nickel-
cadmium rechargeable
b a t t e r y s u p p l y, 3 . 6 V
n o m i n a l , 6 0 0 m A h
capacity.
Power Adapter: 9V DC @ 300mA
SPECIFICATIONS ARE TYPICAL AND
MAY CHANGE WITHOUT NOTICE.
FCC AND IC REGULATIONS