Getting started – VTech 2420 User Manual
Page 12
12
Enter Base ID Code
1.
After charging the Handset, remove
it from its Charge Cradle, the screen
will display:
2.
Press NEW, then enter the 15 digit
Base Unit ID code, located on the
underside of the Base Unit.
3.
Press OK. The Handset will display:
PLEASE WAIT!!
4.
Wait approximately 15 seconds.
The Handset will display:
FOUND BASE
If the Handset displays: BASE
BUSY TRY LATER, this indicates
that the system is in use. Wait until
the Base Unit is in the idle (on hook)
mode, and repeat steps 2 to 4.
NOTE: Occasionally, it may take longer
than 15 seconds for the Handset to confirm
registration to the Base Unit. This is
normal.
Congratulations! You can now enjoy the
benefits of your multi-Handset system.
Registration and Operation
Getting Started
See also other documents in the category VTech Handset Cordless Phone:
- CS2111-11 (56 pages)
- DS6472-6 (2 pages)
- Dect 6.0 DS6211-4 (49 pages)
- Dect 6.0 DS6221-3 (18 pages)
- IP811 (20 pages)
- LS6225-4 (58 pages)
- 20-2432 (51 pages)
- 6051 (53 pages)
- VT2650 (38 pages)
- CS6129-41 (79 pages)
- LS6215-3 (47 pages)
- ip8301 (106 pages)
- 20 (44 pages)
- DS6421-3 (2 pages)
- DS6401 (21 pages)
- DS6151 (2 pages)
- CS6409 (23 pages)
- IA5864 (51 pages)
- 9126 (30 pages)
- CS6329-2 (71 pages)
- ia5865 (61 pages)
- CS6129-3 (1 page)
- CS6429-3 (1 page)
- DS6121-2 (75 pages)
- 6042 (2 pages)
- 915 ADL (4 pages)
- i 5881 (58 pages)
- DS3111-4 (61 pages)
- CS6219 (18 pages)
- LS6125-4 (77 pages)
- ia5847 (52 pages)
- VT2024-31 (13 pages)
- DS221-3 (60 pages)
- CS6124 (53 pages)
- IP 811 (20 pages)
- GiGA5.8x VT5836 (33 pages)
- 2600 (11 pages)
- 2121 (5 pages)
- DS6111 (56 pages)
- IP8300 (118 pages)
- CS6229-5 (61 pages)
- CS5111-3 (56 pages)
- I5808 (44 pages)
- LS5145 (128 pages)
- DECT DS6121-4 (74 pages)