Verona CR 43 - Manual (Page 7)

17
Verona CR 43 - Honda
DE
UT
S
C
H
EN
GLI
S
H
IT
A
L
IANO
POR
T
UG
UE
S
NE
DE
RL
AND
ESP
A
G
ÑO
L
SVEN
SK
A
F
RANÇAI
S
period, “000”. Following this, it is essential
that you enter the correct code number.
Switching Code System Off
If you wish to switch the anti-theft code sy-
stem off:
● turn off the radio,
● simultaneously press, and hold, preset
buttons 1 and 4
;
● turn the set back on. “Cod” will then
appear in the display
: .
● release the preset buttons 1 and 4 ; .
“000” then appears in the display : .
● Enter the code number that is in the
Blaupunkt car radio pass and confirm:
See example “First-time operation ...”.
The anti-theft coding system has now been
deactivated.
Switching the Code System Back On If
you wish to re-activate the anti-theft
code system:
● turn the radio off,
● simultaneously press, and keep de-
pressed, preset buttons 1 and 4
; ,
● turn the set back on. “Cod” briefly ap-
pears in the display
: and then the set
is switched on.
Amplifier Section
ON/OFF
For switching the set on,
● turn button 1 .
Your stereo is now ready for operation.
For switching the set off,
● turn button 1 .
Volume control
● turn button 1 .
Balance Control
Use button 1 to balance the sound impres-
sion of the right and left channel speaker.
● Pull (lock in) button and turn.
After the adjustment
● slightly press button.
Fader control
If four loudspeaker are connected, the front/
rear sound impression of the loudspeakers
(fader) can also be modified using lever
B .
Adjusting trebles
● turn button @ .
Adjusting basses
● turn button A .
The anti-theft code system is now activated.
Now whenever the set is turned on, “CODE”
will appear briefly in the display
: .
Optical indication of theft protection
As optical warning of the encoded car radio,
the LED
6 flashes when the ignition is
switched off, provided the car radio has been
connected correspondingly.
For this, please see the corresponding instal-
lation instructions.