SINBO SCM 2926 - Manual (Page 15)

3. Place an espresso cup on removable cup shelf. Make sure the coffee/steam knob is
on the “ ” position.
Note: the appliance is not equipped with jug, please use your own jug or cup.
4. Connect appliance into power source, press down the ON/OFF button to the lower
position which is the “
ON
” position. The red indicator will be illuminated.
5. The appliance begins to be pre-heated until the green indicator is illuminated, it shows
the pre-heating is finished. Turn the coffee/steam knob to the “ ” position, and water
will flow out.
6. After about one minute, turn the coffee/steam knob to the “ ” position to stop brewing,
you can pour the water in container out then clean them thoroughly, now you can start
brewing.
Note: There may be noise when pumping the water on the first time, it is normal, the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance
before making coffee, including the funnel, steel mesh and cup, so that the coffee flavour
can not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the
water level should not exceed the “MAX” mark in the tank. Then place t he tank into the
appliance properly.
2. Set steel mesh into metal funnel, make sure the tube on the funnel
aligns with groove in the appliance, then insert the funnel into the
appliance from the Insert position, and fix them into coffee maker
firmly by turning it anticlockwise until it is at the lock position (See
fig. 1).
3. Place an espresso cup on removable cup shelf.
4. Then connect the appliance into power supply source. Make sure the coffee/steam
knob is on the “ ” position.
5. Press the ON/OFF button to the lower position which is the “
ON
” position, the red
indicator will be illuminated.
6. When the green indicator is illuminated, you should turn the coffee/steam knob to the
“ ” position, there will be hot water flowing out. After about one minute, close the
coffee/steam knob by turning the coffee/steam knob again to the “ ” position”. The pre-
heating is finished.
MAKING ESPRESSO COFFEE
1. Remove the metal funnel by turning it in clockwise, set steel mesh into metal funnel.
Add coffee powder to steel mesh with measuring spoon, a spoon coffee powder can make
about a cup of top-grade coffee, then press the ground coffee powder tightly with the
tamper.
- 14 -
BEFORE THE FIRST USE