Victor Enterprise 1260-3 - Manual (Page 9)

- 9 -
KEY FEATURES
6. [
↑]
Paper Feed Key
Advance the paper roll.
7. [
→]
Right Shift Key
Deletes right most character of a live entry.
8. [COST] Cost Key
Used to enter the Cost factor in a Gross Profit Margin calculation.
9. [SELL] Sell Key
Used to enter the Selling price in a Gross Profit Margin calculation.
10. [MARGIN] Margin Key
Used to enter the desired Margin in a Gross Profit Margin calculation.
11. [TIME/DATE] Time and Date Display Key
Used to display or program the date and time. Depressing this key
once will cause the date to display, a second depression will display
the time. Holding the key down for three seconds will cause the date or
time to flash, this is the program mode.
12. [RATE] TAX Rate Preset Key
Used to enter TAX rate.
13. [TAX 1] Tax 1 Key
Calculate an amount of tax with tax rate preset by RATE key. Use +
key for calculating an amount including VAT, and – key for calculating
an amount excluding VAT.
14. [TAX 2] Tax 2 Key
Calculate an amount of tax with tax rate preset by RATE key. Use +
key for calculating an amount including VAT, and – key for calculating
an amount excluding VAT.
15. [%+] Percent Key
Completes percent calculation when Multiple or Division key is used.
16. [
÷]
Division Key
The Division key performs division, automatic constant division and
intermediate sequential operations. It establishes the next amount as a
constant divisor. The
÷ key also causes the calculator to divide when
you depress the =, %, M+, M-, X or
÷ key. Each divisor entry is
retained as a constant (except M+ and M- entries) until you depress
the X,
÷ or Clear.
17. [=] Equal Key
To get the result in multiplication or division.
18. [X] Multiplication Key
The multiplication key performs multiplication, automatic constant
multiplication and intermediate sequential operations. It establishes the
amount entered or the prervious printed or printed/displayed amount
as a constant multiplicand. The X key also causes the calculator to
multiply when you depress the =, %, M+, M-, X or
÷ key. Each
multiplicand entry is retained as a constant (except M+ and M- entries)
until you depress the X,
÷, or Clear.