Verizon 595 - Manual (Page 10)

AirCard 595 PC Card User Manual
10
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
FCC guidelines stipulate that the antenna should be more than 1.7 cm from the user.
The highest reported SAR values of the AirCard 595 by Sierra Wireless are:
1. Separation distance of at least 1.7 cm needs to be maintained to user’s lap with AirCard 595 inserted into
the bottom PC Card slot of the laptop computer (1.345 mW/g).
WARNING: DO NOT ATTEMPT TO SERVICE THE WIRELESS COMMUNICATION DEVICE YOURSELF. SUCH
ACTION MAY VOID THE WARRANTY. THE AIRCARD 595 PC CARD MODEM OEM IS FACTORY TUNED. NO
CUSTOMER CALIBRATION OR TUNING IS REQUIRED. CONTACT VERIZON WIRELESS TECHNICAL
SUPPORT FOR INFORMATION ABOUT SERVICING YOUR WIRELESS COMMUNICATION DEVICE.
CAUTION: Any changes or modifications not expressly approved by Sierra Wireless could void the user’s authority to
operate the equipment.
Information pertaining to OEM customers
The AirCard 595 PC Card has been granted modular approval for mobile applications. Integrators may use the
AirCard 595 card in their final products without additional FCC / IC certification if they meet the following conditions.
Otherwise, additional FCC / IC approvals must be obtained.
1. At least 20 cm separation distance between the antenna and the user’s body must be maintained at all
times.
2. To comply with FCC / IC regulations limiting both maximum RF output power and human exposure to RF
radiation, the maximum antenna gain must not exceed 5.65 dBi in the Cellular band and 4.35 dBi in the
PCS band.
3. The AirCard 595 card and its antenna must not be colocated with any other transmitter or antenna within a
host device.
4. A label must be affixed to the outside of the end product into which the AirCard 595 is embedded, with a
statement similar to the following:
This device contains TX FCC ID: N7NAC595.
This equipment contains equipment certified under IC: 2417C-AC595.
5. A user manual with the end product must clearly indicate the operating requirements and conditions that
must be observed to ensure compliance with current FCC / IC RF exposure guidelines.
The end product with an embedded AirCard 595 card must pass the unintentional emission testing and properly
authorized per FCC Part 15 requirements.
Note: If this PC Card is intended for use in a portable device, you are responsible for separate approval to satisfy the
SAR requirements of FCC Part 2.1093 and IC RSS-102.