VTech GIGAPHONE VT2431 - Manual (Page 7)

6
Enter Base ID Code
1.
After charging the Handset, remove
it from its Charge Cradle, the
screen will display:
2.
Press NEW, then enter the 15 digit
Base Unit ID code, located on the
underside of the Base Unit.
3.
Press OK. The Handset will display:
PLEASE WAIT!!
4.
Wait approximately 15 seconds.
The Handset will display:
FOUND BASE
If the Handset displays: BASE
BUSY TRY LATER, this indicates
that the system is in use. Wait until
the Base Unit is in the idle (on
hook) mode, and repeat step 2 to
4.
Congratulations! You can now enjoy the
benefits of your VTECH multi-Handset
system.
Registration
Getting Started