VTech 921 ADL - Manual (Page 6)

6
1. Choose a spot near an electrical outlet
and a telephone jack. Your phone
requires a modular telephone jack and a
standard electrical outlet ( 120v AC). The
power cord is six feet long; make sure
there is an electrical outlet within reach of
the base. The outlet should not be
controlled by a wall switch. If the switch is
ever tur ned off, the phone will not
operate.
2. Position the wall mount adaptor on the
base. Line up the tabs on the wall mount
adaptor with the holes on the bottom of
the base. Snap the wall mount adaptor
firmly in place.
3. Mount the base on the wall. Position the
base so the mounting studs will fit into the
holes on the bottom of the base. Position
the power cord to extend down the wall
the phone is to be mounted on. Slide the
base down on the mounting studs until it
locks into place.
4. Connect the telephone cord(s). The
telephone line cord has a snap-in plug at
each end. Insert one of the plugs into the
jack(s) on the bottom of the base. Insert
the other end of the plug into the wall
jack(s).
5. Plug the AC adaptor on the power cord
into an electrical outlet.
.
WALL MOUNTING
INSERT WALL MOUNT
INTO THE BASE UNIT
SNAP IN FIRMLY
T ONE
PLUSE
LINE 2 RINGER
LINE 1 RINGER
SLIDE DOWN
IMPORTANT
When wall mounting your
921 ADL, you must
reverse the handset hook located in the
charging cradle.
Otherwise your Handset may fall from the
Base Unit when cradled.