Setup, Getting started – VTech 5808 User Manual
Page 7

7
Getting Started
Connecting Power to Base Unit
Plug the power adapter into an electrical outlet, and the connector into the bottom of the base
unit.
Setup
To outlet
Installation and Charge of Battery
Follow these steps:
1. Remove the battery cover and place
the battery in the compartment with
the metal contacts aligning, as shown
in the diagram.
2. Replace the cover by sliding it
upwards.
3. If the new battery is not already
charged, place the handset in its
base unit, and allow it to charge for a
minimum of 12 hours. After initial
charge, a maintenance charge of
eight hours should be sufficient.
See also other documents in the category VTech Handset Cordless Phone:
- CS2111-11 (56 pages)
- DS6472-6 (2 pages)
- Dect 6.0 DS6211-4 (49 pages)
- Dect 6.0 DS6221-3 (18 pages)
- IP811 (20 pages)
- LS6225-4 (58 pages)
- 20-2432 (51 pages)
- 6051 (53 pages)
- VT2650 (38 pages)
- CS6129-41 (79 pages)
- LS6215-3 (47 pages)
- ip8301 (106 pages)
- 20 (44 pages)
- DS6421-3 (2 pages)
- DS6401 (21 pages)
- DS6151 (2 pages)
- CS6409 (23 pages)
- IA5864 (51 pages)
- 9126 (30 pages)
- CS6329-2 (71 pages)
- ia5865 (61 pages)
- CS6129-3 (1 page)
- CS6429-3 (1 page)
- DS6121-2 (75 pages)
- 6042 (2 pages)
- 915 ADL (4 pages)
- i 5881 (58 pages)
- DS3111-4 (61 pages)
- CS6219 (18 pages)
- LS6125-4 (77 pages)
- ia5847 (52 pages)
- VT2024-31 (13 pages)
- DS221-3 (60 pages)
- CS6124 (53 pages)
- IP 811 (20 pages)
- GiGA5.8x VT5836 (33 pages)
- 2600 (11 pages)
- 2121 (5 pages)
- DS6111 (56 pages)
- IP8300 (118 pages)
- CS6229-5 (61 pages)
- CS5111-3 (56 pages)
- I5808 (44 pages)
- LS5145 (128 pages)
- DECT DS6121-4 (74 pages)