VDO Cytec C05+ User Manual

Page 19

8 . Battery change

Tip:

Take down your total distance and wheelsize prior to battery change.

8.1 Changing the battery in the computer head

see chapter 1.4.

Watch out:

old batteries require special disposal

9. Troubleshooting

This chart outlines possible malfunctions, their causes and solutions.
malfunction

possible cause

solutions

speed display

check for proper distance between

readjusting distance between sensor

does not appear

sensor and magnet

and magnet

sender battery empty

check battery power and
replace if necessary.

computerhead is incorrectly twisted on

place computerhead on handlebar

handlebar holder

holder and twist until detent (CLICK)

no wheelsize entered

enter your wheelsize

sender is too distant from computerhead mount sender closer to computerhead

display fades

battery in computer empty

check battery power and replace it if

or disappears

necessary

temperatures below 5

C (40

F) dull

back in normal temperatures, display

display readout

picks up working correctly

10. Warranty

We warrant VDO CYTEC models (sensor, computer head and handlebar holder) to the original purchaser
for five years from date of purchase against defects in material and workmanship. This does not cover
the batteries and defects resulting from normal wear and tear, improper care, accidents,
abuse or alteration.

Please take care to retain your receipt of purchase.

In case of legitimate complaints, you are entitled to receive a comparable replacement model. Due to
possible model changes, your model might not be available any more.

You may contact your retailer or store where you purchased your
VDO CYTEC or send the computer directly to us:
CYCLE PARTS GMBH
Grosse Ahlmuehle 33
76865 Rohrbach / Germany

In case of technical queries, call our consumer-service-hotline Tel. +49-6349-9635-10

Technical specifications of VDO CYTEC C05+ are subject to change.