Verilux DESK AND TABLE LAMP VD05 - Manual (Page 6)

3
Assembly Instructions
Before assembling, please review all instructions.
1. Carefully lay out all parts on flat surface and refer to diagrams on
page 4 of this manual.
2. Screw post (C) into the base (A) and hand tighten.
3. Loosen the thumbscrew (B) to adjust the lamp height. Adjust the
lamp (D) to the desired height and tighten the thumbscrew (B).
4. Rotate shade (F) to right angle with body (D) and parallel to the
floor. Then, use the supplied Allen wrench (E) to carefully tighten
the screw.
5. Remove thumbscrew from Optix ® filter on lamp head and carefully
slide filter out of channel and place on clean surface (Fig. 1).
6. Remove the 27 Watt Natural Spectrum ® bulb from the packaging
and carefully insert it into the socket (Fig. 2). Be sure to hold the
bulb by the base and ensure it is fully inserted into the socket and
clipped into the metal clip. Note: the telephone number on the bulb
provides contact information when reordering.
7. Slide Optix filter back into place and re-install thumbscrew (Fig. 5).
Do not over tighten.
8. Plug lamp into an appropriate outlet and turn on the switch.
9. Do not use with an extension cord or on a circuit with a dimmer
switch.
10. Save the packaging in case you need to send the lamp to Verilux ®
for servicing.