Storing pauses in memory, Using redial, Storing a redial number into speed dial – VTech Telephone User Manual
Page 11: Operating instructions
11
Storing Pauses in Memory
•
To insert a pause in a phone number,
press REDIAL/PAUSE. The pause is
2 seconds in length. For longer
pauses, press REDIAL/PAUSE two or
more times. Each additional press
adds an additional 2 seconds pause.
•
If your phone is connected to a PBX
you can store the PBX access number
and a pause before the phone number.
For example, to store 9-PAUSE-555-
1234 in memory location 8 do the
following:
•
Press MEM/PROG.
•
Press 8.
•
Press 9.
•
Press REDIAL/PAUSE.
•
Dial 555-1234.
•
Press MEM/PROG.
Using Redial
•
To redial the last number you called,
press PHONE then press REDIAL/
PAUSE. The phone will automatically
dial the number.
Storing a Redial Number into Speed
Dial
•
To store the last number you dialed as
a Speed Dial number, press MEM/
PROG, a location number (0-9),
REDIAL/PAUSE, MEM/PROG.
The Page Feature
•
From the Base Unit, press PAGE to
signal the person at the Handset.
•
To end the page at the Base, press
PAGE again.
•
To end the page at the Handset, press
OFF.
•
If the Handset is in use (off-hook)
when PAGE is pressed on the base
Unit, the Handset will not emit one
page alert. If the Handset is not in use
(on-hook), the page alert will continue
for approximately 60 seconds.
•
This feature is useful in locating a
misplaced Handset.
Operating Instructions