Quick installation, Turning on the unit for the first time – Venturer PLV76156 User Manual

Page 4

E - 3

Before turning on your television set for the first time, be sure to place it on a solid stable surface. To avoid

danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct

the ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.

QUICK INSTALLATION

7 7/8"

2 3/8"

TURNING ON ThE UNIT FOR ThE FIRST TIME

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt

message on the screen to complete basic TV settings.

Make sure the TV antenna or CATV cable has been connected properly to the

TV ANTENNA input jack on the rear of the system.

1. Connect the TV antenna.

2. Connect the power cord.

3. Press the

/ ON button to turn on the unit.

4. Press the / button to highlight Antenna,

then use the

ENTER or button to select

“Air”, “Cable STD”, “Cable HRC”, “Cable IRC”

or “Cable Auto“.

5. Use the / button to highlight Auto

Scan, then press the

ENTER or button to

confirm.

6. The unit will immediately search all channels

for those with adequate signal strength and

store those channels with signals in memory.

The unit will take a few minutes to finish auto

scan and after this is completed, the unit will

switch to the first channel found.

To Stop

Analog Air Channel 10

Analog Channels Found

Autoprogram Menu

Digital Channels Found
Progress(%) 5

Not Found

To Move

To Select

To Exit

Enter

OSD Language

Antenna

Initial Setup Menu

Auto Scan

Air

English

PLV76156S7_IB_UL_090727.indd 3

7/28/2009 09:41:04