beautypg.com

Installing to wall, Notice, Warning – Vanguard Heating VP2000BB User Manual

Page 9: Caution

background image

9

100100

INSTALLING

TO WALL

NOTICE

A qualified service person must install heater. Follow all local codes.

Continued

LOCATING HEATER

This heater is designed to be mounted on a wall.

You can locate model VP2000BB on floor, away from a wall. An optional floor
mounting stand is needed. Purchase the floor mounting stand from your dealer. See
Accessories, page 27.

WARNING ICON

G 001

WARNING

Maintain the minimum clearances shown in Figure 4 (page 10). If you
can, provide greater clearances from floor, ceiling, and joining wall.

WARNING ICON

G 001

WARNING

Never install the heater

• in a bedroom or bathroom
• in a recreational vehicle
• where curtains, furniture, clothing, or other flammable objects are

less than 36 inches from the front, top, or sides of the heater

• as a fireplace insert
• in high traffic areas
• in windy or drafty areas

WARNING ICON

G 001

CAUTION

This heater creates warm air currents. These currents move heat
to wall surfaces next to heater. Installing heater next to vinyl or
cloth wall coverings or operating heater where impurities in the air
(such as tobacco smoke) exist, may discolor walls.

IMPORTANT:

Vent-free heaters add moisture to the air. Although this is beneficial, in-

stalling heater in rooms without enough ventilation air may cause mildew to form from
too much moisture. See Fresh Air for Combustion and Ventilation, pages 5 through 8.

CHECK GAS TYPE

Use only propane gas. If your gas supply is not propane, do not install heater. Call
dealer where you bought heater for proper type heater.

INSTALLATION ITEMS

Before installing heater, make sure you have the items listed below.

• external regulator (supplied by

installer, see page 14)

• piping (check local codes)
• sealant (resistant to propane gas)
• manual shutoff valve *

• ground joint union
• test gauge connection * (see

Figure 13, page 15)

• sediment trap
• tee joint
• pipe wrench

* An A.G.A. design certified manual shutoff valve with 1/8" NPT tap is an acceptable
alternative to test gauge connection. Purchase the optional A.G.A. design certified
manual shutoff valve from your dealer. See Accessories, page 27.

This manual is related to the following products: