beautypg.com

E4100, Assembly – Vision Fitness E4100 User Manual

Page 6

background image

E4100

Assembly

6:

Slip the Front Transport Wheel (61) onto the right side of the Front

Foot Wheel Axle (60). Secure this wheel with the Outside Wheel

Washer (182) and the Wheel Attach Nut (183). This nut should be

tightened until the wheel has no side-to-side play, but it can still

be easily rotated with your fingers.

7:

Tighten the Cam Pulley Locknut (183). NOTE: This nut must be

tightened all the way down or the Pulleys may loosen. When the

Locknut is properly adjusted, the Outside Cam Pulley (106) can

be turned with your fingers, and there will be no side-to-side play

in the arm.

NOTE:

Production models prior to 3/97 had TWO Cam Pulley

locknuts instead of the newer SINGLE Cam Pulley Locknut (183).

8:

Repeat the above procedure with the Left Arm (115).

9:

Tighten the Axle Bushing Allen Bolts (157). Snap the Plastic Arm

Cam Covers (74) into place on each arm. Check that they are

secure and even.

NOTE

Symptom:

Too much resistance.

Cause:

The black Cam Follower Pulleys OR the Wheel Axle Nuts

have been overtightened. When the nylock Cam Pulley Locknut

(183) has been tightened, the cam pulley should be able to be

turned with your fingers. If it cannot be turned, the nylock nut is

too tight. Also check that the wheel axle nuts are not too tight.

The wheels should also be able to be turned with your fingers. If

not, the axle nut is too tight.