Vivitar VIVICAM 8027 - Manual (Page 8)

7
Full battery power Medium battery power Low battery power
Note:
1. A “Low battery” message will flash on the LCD when the battery power is insufficient. Shortly
thereafter your camera will power off.
2. Please remove your battery when you don
’t intend to use your camera for a long time.
3. The test photo taken with the camera should be downloaded otherwise they will be lost when the
camera loses power and turns off or when the battery door is opened to replace the battery.
4. In order to charge your lithium battery, make sure the battery is inserted correctly and then
connect your camera to an on and running PC with the USB cable provided. The red LED
situated above the T/W Zoom buttons will light up indicating that your camera is in charging
mode. The LED will switch off when your camera is fully charged.
Installing SD Memory Card
Your camera has a memory card slot that enables you to insert any “SD” compatible memory card up to 8GB.
An SD memory card is needed for normal use. Adding a memory card will allow you to increase the capacity
of your camera before you have to transfer photos and videos to your PC.
1. Locate the Memory Card slot within the battery compartment.
2. Insert the Memory card into the slot in the correct direction.