Vinotemp VT - IMSW - Manual (Page 9)

9 1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
TROUBLESHOOTING GUIDE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before contacting Vinotemp.
PROBLEM POSSIBLE CAUSE
Ice maker does not power
on • Not plugged in.
• A tripped circuit breaker or a blown fuse.
• Ice maker control switch is set in “OFF” position.
Ice maker is on but not
producing ice • Airflow to front grill is blocked
• Ice maker arm was set in the “OFF” position
• Water supply is turned off
• Water line is crimped; water is not reaching unit
• Ice maker has excessive frost build up
Compressor turns on and
off frequently • Room temperature is warmer than normal.
• Appliance door is open too often.
• Door is not closed completely.
• Door gasket does not seal properly.
• Ice maker does not have adequate ventilation. Check
to ensure that the grill is unobstructed and condenser
coils are clean.
Excessive vibrations • Check to assure that the ice maker is level. Adjust the
leveling legs as needed.
Ice maker seems to make
too much noise • A rattling noise may come from the flow of the
refrigerant; this is normal.
• As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your appliance.
• Contraction and expansion of the inside walls may
cause popping and crackling noises.
• Ice maker is not level.
Door will not close properly • Ice maker is not leveled.
• Door was reversed and not properly installed.
• Door gasket is dirty.
• The ice bucket is out of proper position.
Ice cubes are melted
together • Ice maker door is opened too often