ViewEra V191HV - Manual (Page 6)

5
2. Installation
The monitor is equipped with an automatic sensing AC power adapter for a voltage range from 100 to 240 VAC at
a frequency of 50 to 60 Hz. Before connecting the cables, please make sure that the monitor and the computer
power are both turned off. Please follow the steps to install your monitor.
a. Security Monitor Rear Panel b. Video Monitor Rear Panel
2.1 Connecting the signal cable
Plug one end of the VGA cable or video cable to a computer or a video device and the other end to the video
signal connector on the monitor, and then tighten the two screws on the cable connector on both ends.
2.2 Connecting the power adapter and power cord
First, connect the AC power adapter to the DC jack on the monitor. Second, connect one end of the power cord to
the power adapter and the other end to the electrical outlet
2.3 Connecting the audio cable
Plug one end of the audio cable to audio jack on the computer or a video device and the other end to the audio
jack on the monitor.
2.4 Installing the monitor base
Place the monitor base on the monitor stand and align the screw on the monitor base against the screw hole on the
monitor stand. Then tighten the screw until the monitor base is securely attached to the monitor stand.