Victory VPT-119-NS - Manual (Page 5)

4. Remove the front refrigeration cover. A power switch is located in the front upper left corner of the refrigeration
compartment.
5. Move the power switch to the “ON” position.
*Note: The power switch located in the front of the refrigeration compartment must be in the “ON” position for the Pizza
Table Refrigerator to operate.
Figure 1 Figure 2
Temperature Controls
Temperature Controls for the pizza table refrigerator storage and pan rail areas are set at the factory to maintain NSF
Standard 7 holding temperature. The temperature controls are located behind the front grill and should only be adjusted
by a qualified technician.
Refrigerated Pan Rail & Night Switch
The refrigerated pan rail is a “Food Holding” area only and is not approved for
storage of food. It is recommended that at the close of each work day, the food in
the pan rail be removed and stored in a refrigerator.
A night switch has been provided to turn off the pan rail when not in use and is
located on the front grill. This will help save energy and make cleaning easy.
The pan rail is “ON” when the night switch inside the refrigerated pan rail label
displays a green light. “OFF” position is indicated when the night switch is not
displaying a green light. See “Refrigerated Pan Rail Label”.
Installing Replacement Door Gasket (if required)
Removing
Beginning at one corner, pry gasket loose from the retaining strip. Peel remainder of gasket from the door and discard.
Replacing
Before replacing, be sure the gasket and door are at room temperature. (If necessary, soak the gasket in warm water to
make it more pliable.) Align new gasket frame on the door retainer strip. Starting at one corner, press each corner of
the gasket into the retainer strip. Once started, the gasket can be easily inserted around the entire perimeter of the door
by simply press rolling into place.
Installation Checklist
After the cabinet has been installed, leveled and cleaned as described, refer to the following checklist prior to start-up.
Check for proper electrical hook-up.
Check exposed refrigeration line connections for leaks. Make sure refrigeration lines are not dented, kinked or rubbing.
Check condenser fan for freedom to rotate without striking any stationary members.
Check that cabinet is level.
Check to see if back of cabinet has the required 2” (inch) minimum clearance from the wall or any flat surface.
Product Load
After the Pizza Table Refrigerator has been started and reaches the proper storage temperatures, food may be loaded.
For optimum energy efficiency, we recommend allowing a 1-1/2” clearance between the interior cabinet wall and product
load.
2
“Refrigerated Pan Rail Label”