VTech CORDLESS TELEPHONE VT 9152 - Manual (Page 18)

18
HEADSET OPERATION
A
D
V
ANCED OPERA
TION
Your VT 9152 cordless telephone is equipped with a 2.5mm Headset Jack for use with an
accessory Headset for hands-free operation.
Locate the Headset Jack on the
VT 9152 handset. Connect line plug on the Headset cord to
the jack on the cordless Handset. The plug should in securely. Do not force the connection.
BELT CLIP
* The VT 9152 is also equipped with a detachable
belt clip. Align the pins on the inside edge of the
belt clip with the notches on the side of the
VT 9152 handset. The belt clip should snap
securely into place. Do not force the connection.
See Illustration.
OPERATION
NOTE: Whenever a compatible Headset is connected
to the cordless Handset, the microphone on the Hand-
set will be MUTED. This is done to limit the effect of
background noise.
* The following operational characteristics apply to
VTECH Headsets. the same may also apply to
other (non-VTECH) compatible headsets, but
VTECH assumes no responsibility for their
performance.
* The VTECH brand compatible Headset has a
monaural design which is reversible, so you can
wear your Headset on either the left or right ear,
leaving one ear free for room conversation.
* The headband can be adjusted to fit the contour
of your head. Using both hands, slide the headband
up or down so that it rests comfortably on your
head with the speaker cushion centered against
your ear.
* For maximum sound quality, the flexible micro-
phone should be positioned at the corner of your
mouth, about one inch from your mouth.