beautypg.com

Univex 200BW8 User Manual

Page 15

background image

durch Röntgenstrahlen" festgelegten Vorschriften.

Auf der Rückwand des Gerätes befindet sich ein Aufkleber, der auf die Unbedenklichkeit der

Inbetriebnahme hinweist, da die Vorschriften über die Bauart von Störstrahlern nach Anlage III ¤ 5 Abs.

4 der Röntgenverordnung erfüllt sind.

Damit Ihr Monitor immer den in der Zulassung geforderten Werten entspricht, ist darauf zu achten, daß

1.

Reparaturen nur durch Fachpersonal durchgeführt werden.

2.

nur original-Ersatzteile verwendet werden.

3.

bei Ersatz der Bildröhre nur eine bauartgleiche eingebaut wird.

Aus ergonomischen Gründen wird empfohlen, die Grundfarben Blau und Rot nicht auf dunklem

Untergrund zu verwenden (schlechte Lesbarkeit und erhöhte Augenbelastung bei zu geringem

Zeichenkontrast wären die Folge).

Der arbeitsplatzbezogene Schalldruckpegel nach DIN 45 635 beträgt 70dB (A) oder weniger.

ACHTUNG: BEIM AUFSTELLEN DIESES GERÄTES DARAUF ACHTEN, DAß

NETZSTECKER UND NETZKABELANSCHLUß LEICHT ZUGÄNGLICH SIND.

RETURN TO TOP OF THE PAGE

End-of-Life Disposal

Your new monitor contains materials that can be recycled and reused. Specialized companies can

recycle your product to increase the amount of reusable materials and to minimize the amount to be

disposed of.

Please find out about the local regulations on how to dispose of your old monitor from your local Philips

dealer.

(For customers in Canada and U.S.A.)

This product may contain lead and/or mercury. Dispose of in accordance to local-state and federal

regulations.

For additional information on recycling contact

www.eia.org

(Consumer Education Initiative)

RETURN TO TOP OF THE PAGE

Information for UK only

WARNING - THIS APPLIANCE MUST BE EARTHED.

Important:

This apparatus is supplied with an approved moulded 13A

plug. To change a fuse in this type of plug proceed as

follows:

1. Remove fuse cover and fuse.

2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or

BSI approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it

should be cut off and an appropriate 3-pin plug fitted in its

place.

If the mains plug contains a fuse, this should have a value

of 5A. If a plug without a fuse is used, the fuse at the

distribution board should not be greater than 5A.

Note: The severed plug must be destroyed to avoid a

possible shock hazard should it be inserted into a 13A

socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured in accordance

with the following code:

BLUE - "NEUTRAL" ("N")

BROWN - "LIVE" ("L")