Uniden TRU 8885 SERIES User Manual

Page 32

G E T T I N G S T A R T E D [ 3 1 ]

w w w . u n i d e n . c o m

Setting the Dial Mode

Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.

• If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If

the call connects, leave the setting as is; otherwise set the unit to pulse dialing.

• If your phone system requires pulse dialing and you need to send DTMF tones in certain

situations during a call, you may switch over to tone dialing (refer to “Tone Dialing
Switch-over” on page 38).

1) Enter the Global Setup menu, and then the Dial Mode

submenu (see "Entering the Menu" on page 16).

2) Press

volume up/down to select

T one

Pul se

(the

initial setting is Tone).

3) Press the OK soft key. You will hear a confirmation tone.

& K C N / Q F G

6 Q P G

2 W N U G

$#%-

& ' . ' 6 '

TTIN

S
T

TRU8885_1st.book 31 ページ２００４年１月７日　水曜日　午後６時３９分