Uniden 2155 - Manual (Page 21)

Registration Process
Follow this process for each additional Handset (DSS2105) that needs to be registered to the
Main Base or for registering your Main Handset.
1. Remove the Handset from its charger
2. Press flash/reg on the Handset (Fig 1).
3. For Handset DSS2155 - Press the number 2 (Fig.2) to register as Handset 2 (Handset numbers
2-7 are available).
For Handset DSS2165 - Press the number 3 to register Handset 3 (Handset numbers 3-7
are available).
15
If a Handset is registered at
any time as Handset 1, all
other Handsets will need to
be registered again from
Step 1.
The Handset/s supplied with your DSS2155/DSS2165 have already been registered. For
additional Handsets it is very important to allocate each Handset a different number to enable
functions such as Call Transfer.
After Registration the
Handset number is shown on
the Display screen either
during a call or while the
Handset is charging (Fig 4).
The Registration process
needs to be completed within
15 seconds, 5 beep tones will
indicate that the time has been
exceeded. Please start the
process again.
REGISTRATION
REGISTER AS
HAND #2
Fig 2.
Fig 1.
Handset
Registration
number
displayed
HANDSET 1
NEW: 0
TOTAL: 0
TALK HIGH 1
Fig 3.
Fig 4.
Charging On a Call
If you have additional
Handsets, repeat the same
process, but at Step 2 select
a number from 3 - 7 to
register the next handset.
4. Place the handset in the Main Base Unit (Fig 3).
5. Press and hold the Registration button located on the
back of the Main Base unit near the DC power jack (Fig 3).
Hold the Registration button in until a long beep
confirms the handset has been registered.