Uniden DECT 1812 - Manual (Page 4)

Installing the Handset Batteries
Press battery cover release.
Slide cover off.
Install the 3 rechargeable Ni-MH
batteries.
Slide the battery cover back
until it snaps into place
Place the handset on the base and
charge uninterrupted for 14 hours.
+
-
-
+
-
-
Registering a handset to a base unit
Each handset must be registered to a base unit in
order to make and receive calls. A handset can be
registered to up to four base units.
• press and hold the
[PAGE] key on your base
until ringing begins (5-10 seconds). You will
then be ready to register another handset to
your base unit.
• press [menu] key on the handset until you
reach the
H-REGISTER
display on the LCD.
• press [OK] key to choose this menu item.
•
SEARCH BS 2
will be displayed.
• press [menu] key to scroll between base units
2-4 (any available Base number is OK).
• press [OK] to confirm your choice.
• the RFPI code will be displayed after a short
wait.
• press [OK] to confirm.
• enter your base unit PIN number and press
[OK] .( Factory default is 1590).
To make a call
1. Press talk [ ] and listen for the dial tone.
2. Dial phone number.
OR
1. Dial phone number
2. Press the talk [ ] key.
To hang up
Press talk [ ] or place the handset back on
the base unit.
To answer a call
Handset on the base unit: Remove handset from
the base and speak
Handset off the base unit: Pick up handset, press
the talk [
] key and speak
Charging the Battery Using the Phone
iii
Only use the battery pack supplied or rechargeable AAA
Ni-MH Batteries.
DO NOT USE STANDARD BATTERIES.