Uniden 7100A - Manual (Page 9)

INSTALLATION
INST
ALLA
TION
Disconnect the telephone line cord before replacing
the battery.
Always use a new 9V alkaline battery for optimum performance.
Follow these steps to install the backup battery.
1. Use a Phillips screwdriver to remove the screw on the
compartment cover.
2. Push down the latch to release the battery compartment cover.
3. Snap the battery’s contacts firmly to the battery connector, then
place the battery into the compartment.
4. Replace the cover and secure it with the screw.
Dispose of old battery promptly and properly.
17
INST
ALLA
TION
CONNECTING POWER
Use only the Uniden AC Adaptor supplied with this
Uniden 7100A Digital Telephone Answering Machine.
1. Plug the AC Adaptor into the power socket at the rear of the DTAM
labelled “9 V AC 400mA”.
2. Then plug the other end into your mains socket.
When you first connect power, the DTAM beeps once and
announces "Please wait". The message counter counts up from 0
to 18. Then the DTAM beeps.
, , , and alternatively
appear to indicate that no outgoing messages are recorded.
BACKUP BATTERY
If the power fails or you unplug the DTAM, a 9V backup battery (not
supplied) would save the messages and the settings for the day, time
and security code. We recommend you use an alkaline battery.
INSTALLATION
16
3653 Uniden 7100A Booklet 27/7/98 1:09 PM Page 16