Unwind DT-920 - Manual (Page 3)

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
These markings are located on the bottom, side or back of the unit.
CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol indicates that dangerous
voltage constituting a risk of electric shock
is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompany-
ing this unit.
CONNECTIONS
1. Connect the FM and AM antennas as shown below.
FM antenna
The T-shaped indoor FM antenna (300-ohm) is sufficient
to receive most local FM broadcasts and should be
connected to the rear FM terminals on the DT-920.
Infringe areas, or where reception is distorted or noisy,
an FM outdoor antenna (not supplied) should be
connected instead of the indoor antenna. The terminals
will accept 300-ohm twin lead cable.
AM antenna
The AM loop antenna is
sufficient to receive most
local AM broadcasts.
Assemble the loop antenna
Unwind the antenna wires
(about 3 turns), then
connect them to the AM
LOOP terminals. Place the
loop antenna in a position
which yields the best AM
reception, or attach it to a
wall or other surface as
shown.
NOTE:
To minimize noise...
- Keep the speaker wires, power cord and all other cables away from
the antennas.
- Do not place the antenna close to a TV or speaker.
2. Connect one end of a supplied audio cable to the
OUTPUT (1 or 2) jack on the TUNER and the other end
to the AUX input jack (-20 to 0dBV, 10k ) of the 900
series II amplifier.
3. After making all the connections, connect the AC power
cord to 120V AC 60Hz outlet.
This unit is equipped with a polarized plug. If you have
difficulty inserting the plug, turn it over and reinsert it. If
the unit will not be used for a long time, disconnect the
AC plug from the AC outlet.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION:
POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE
LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'
AU FOND.
CAUTION:
Loose or incorrect connections will result in poor sound or
improper operation.
900 SERIES II AMPLIFIER
DT-920
-2-