U-Line pmn User Manual
Page 13

5.
Remove existing bottom hinge (3 screws) and remount on oppo-
site side TOP. Remove top hinge screw pin.
6.
With bottom of door facing up, remove pivot plate (2 screws), flip
over, and remount on opposite side of door (see Figure 13).
Figure 13
7.
Holding door upright with top of
door tilted forward, place hole of
door pivot plate on bottom hinge
screw pin (see Figure 14).
8. Tilt top of door into position in top
hinge and install top hinge screw
pin.
9.
Install plastic screw plugs
removed in Step 2 in existing hinge
holes (3 each, top and bottom).
Figure 14
UL312A
UL319
11
See also other documents in the category U-Line Refrigerators:
- 2175RC (24 pages)
- 2115WCOL (2 pages)
- COMBO 2175RF (28 pages)
- 2175WCOL (24 pages)
- 2075 (31 pages)
- 2175WCC (20 pages)
- 1175BEV (32 pages)
- CAPTAIN 1115WC (2 pages)
- 1175WC (16 pages)
- 29R (32 pages)
- 2275XWCOL (20 pages)
- 2175BEVS (16 pages)
- 2275DWRCS (17 pages)
- 1075BEV (2 pages)
- CO75 (24 pages)
- 75 (56 pages)
- 2175BEV (2 pages)
- ADA SERIES ADA24RGL (20 pages)
- 2175DWRR (20 pages)
- CO2175DWR (20 pages)
- 2175R (20 pages)
- CO1175 (22 pages)
- CO29 (19 pages)
- 2175BEVOL (24 pages)
- CLR2160OD OUTDOOR (20 pages)
- 1115R (24 pages)
- 2175WCOL2 (20 pages)
- ICE-MAKER/REFRIGERATOR (33 pages)
- CO2175FF 2175RF (24 pages)
- 2275ZWCOL (24 pages)
- COMBO CO29 (20 pages)
- CO29FF (20 pages)
- 2175BEVOL2 (17 pages)
- 2175RF EN (17 pages)
- COMBO 29WHTP (1 page)