UNICOM Electric DYNA SWITCH FEP-31016T-1 - Manual (Page 5)

Figure 4. Front panel view of LED indicators
Status LEDs
Network Application
This section provides a few samples of network topology in which the
Switches are used. The Dyna-Switch/16 and 24 are designed to be
used as segment switches. With their large address tables (8K MAC
address) and high per formance, they are ideal for interconnecting
networking segments.
You can use the Dyna-Switch/16 and 24 to connect PCs, workstations,
and ser vers to each other by connecting these devices directly to a
Switch. The switch automatically learns node addresses, which are
subsequently used to filter and for ward all traffic based on the
destination address.
Small Workgroup
The Dyna-Switch/16 and 24 can be used as standalone switches
interconnecting personal computers, ser vers, and print ser vers forming a
small workgroup.
5 4
LK/ACT
FD/COL
FD/COL
LK/ACT
Dyna -Switch /16
16 Port 10 / 100Base-TX Switch
POWER
LINK/ACT and FDX/COL
Indicators
Power Indicator
LED Status Color Description
Power On Green The switch is supplied with
suitable power.
On Green The por t is connecting with
the device.
LINK/ACT Blinks The por t is receiving or
transmitting data.
Off The port is not linked
successfully with the device.
On Orange The por t is operating in Full
Duplex mode.
FDX/COL Blinks A packet collision occurred at
this por t.
Off No device attached or the port is
operating in Half Duplex mode.
Printers
Server
Workstations
LK/AC T FD/COL FD/COL LK/AC T
Dyna -Switc h /16
16 Po rt 10/ 100Base -TX Switc h POW ER
Figure 5. Small Workgroup Application