Uniden BC796D APC0 25 - Manual (Page 58)

Programming LTR Systems
Follow the instructions in this section to program information for LTR trunking systems. For
more information about LTR systems, refer to “Understanding Scanning.”
2:SCAN OPTION → 2:TRUNK → Enter the bank → 1:TRUNK TYPE →
1:ON → 9:LT → 2:TRUNK CHANNEL
1. Enter the channel number.
1:FREQUENCY
2. Enter the frequency and alpha tag for the channel.
Repeat these steps for all channels in the system. Then, refer to “Programming
Talkgroups.”
Note: LTR systems must be programmed in channel order, skipping unused channels. For
example, if the LTR system you are programming uses only Channels 1, 3, 5, and 7,
program frequencies in the first, third, fifth, and seventh channels in the bank.
52
BC796D(NEW) 10/20/03 11:30 AM Page 52