M-AUDIO Mixim 10 - Manual (Page 11)

11
enables you to incorporate stereo effects in your mix. If you need
more than one stereo return, use two of the regular channel
inputs. This technique also enables you to adjust the placement of
the effect in the stereo field by adjusting the pan pots on the chan-
nels to which you have routed the effects unit.
For the best S/N ratio, set the send level on the miXim 10 so that
the effects unit is getting the “hottest” possible signal without
overloading. Set the effects unit to output wet (processed) signal
only and use the miXim 10's return level to control the mix of
processed and non-processed signal.
Block Diagram - Fig. 3
SEND
XLR
GAIN
SWITCH
LEFT BUS
RIGHT BUS
9 IN
10 IN
STEREO
RETURN
LEDs
LEFT
MAIN
OUT
LEFT
PHONES
OUT
LEFT
LEDs
RIGHT
MAIN
OUT
RIGHT
PHONES
OUT
RIGHT SEND
CHANNELS 1 and 2
PAN GAIN EQ
1/4"
SEND
CHANNELS 3 and 4
GAIN EQ
GAIN
PAN
BALANCE
SEND
CHANNELS
5 & 7
CHANNELS
6 & 8
MAIN