Ultra electronic Turbo - Manual (Page 2)

Quick Start Guide Ultra Electronics Card Systems
Page 2 MAGICARD Color Printer
Setting up your MAGICARD TURBO Color Printer
takes just three easy steps:
1.
Unpack and install the printer
A Preparing a Location for the Printer
B Removing the Printer from the Box
C Checking the Package Contents
D Install the Dye Film
E Load the Plastic Cards
F Cleaning the Card Cleaning Roller (sticky or tacky roller)
G Connect the Printer to a Power Supply
H Test the Printer Operation
I Install the Parallel Interface Cable and Ultra Secure Key
2.
Load the supplied WINDOWS Driver software.
Jx Install the WINDOWS Driver (WINDOWS 3.x)
Jy Install the WINDOWS Driver (WINDOWS 95)
K Printer Setup
L Install the WINDOWS Driver (WINDOWS NT4)
3.
Verify computer-to-printer operation.
M Verifying Computer to Printer Communication in WINDOWS
N In Case of Difficulty.
P Important Cleaning procedures.
Q LED Error Codes
Note: The Ultra WEB site at http://www.ultra.co.uk contains comprehensive technical support information
including the latest downloadable software, WINDOWS Drivers, Technical Bulletins etc
Conventions
Throughout this guide, the following conventions are used to identify important
information.
WARNING - Warning messages indicate where personal injury could result from
not following the correct procedures.
CAUTION - Caution messages indicate where damage to equipment could result
from not following the correct procedures.
NOTE - Notes convey important information that is identified within the text.