U-Line 1175BEV - Manual (Page 20)

20 1115R, 1175R, 29R, 1175BEV
Figure 40
7. Remove screws on opposite side of cabinet (Figure 40).
Note that there may be a nut behind one or both
screws on either side.
Figure 41
8. Install hinge on opposite side, bottom of cabinet
(Figure 41). Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
Figure 42
9. Relocate plastic spacer/bushing (Figure 42, 1) on
bottom of door to opposite side, and place door on
bottom hinge pin. Clean out bushing hole in door
bottom with a screwdriver if needed.
Figure 43
10. Remove plastic hole plug from door handle and
relocate on opposite side (Figure 43).
11. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge (Figure 43).
Figure 44
12. Remove three plastic screw plugs (Figure 44) in hinge
holes, top of cabinet, opposite side. Be careful not to
scratch cabinet.
13. Place door on lower hinge pin. Invert and install upper
hinge on door.
ULIN_0122 _A
ULIN_0123 _A
1
ULIN_0109_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0142_A
ULIN_0144_A
ULIN_016357_30087.fm Page 20 Tuesday, March 14, 2006 2:36 PM