U-Line 1115R - Manual (Page 15)

U-Line 1000 Series Maintenance 13
Removing and Installing Interior Shelves
Removing and Installing Door Shelves
For models equpped with door shelves:
To remove the door shelf:
1. Grasp shelf in center, and lift until the shelf notches (1) clear
the pins (2).
2. Carefully pull the shelf away from the door.
To install the door shelf:
1. Holding the shelf in the center, center the shelf in the door at
the desired location, slightly above the pins (2).
1
2
For models equipped with glass shelves having recessed shelf
supports, remove the shelves as follows:
1. Pull shelf out about 6" (1), until back of shelf clears the “hump”
on the right-hand side.
2. Tilt up right-hand edge of shelf (2).
3. Remove shelf from unit by pulling out (3).
Insert the shelves as follows:
1. To move to a different position in the unit, insert shelf at an
angle, approximately 15-20°, over the rib in the side of the unit
where you want to place the shelf. Place the shelf into the unit
at an angle to clear the door.
2. Continue to slide the shelf into the unit at an angle until it clears
the door.
Lower the shelf and push it in completely. Ensure the raised edge
strip is toward the rear of the unit and the decorative graphics,
if applied, are on the underside of the shelves.
IMPORTANT IMPORTANT
• Make sure the shelves are inserted fully into the unit.
The edge strip toward the rear prevents cans and
bottles from freezing against the cold evaporator.
For models equipped with glass shelves having shelf supports,
remove the shelves as follows:
1. Open door completely.
2. Grasp the shelf edge in the center and slide the shelf from the
unit.
Insert the shelves as follows:
Reposition the shelf as required, ensure the raised white edge
strip is toward the rear of the unit and graphics, if applied, are
on the underside of the shelves.
2
3
1