Uniden DCX291 - Manual (Page 2)

2 - English
INSTAllING YOUR HANDSET
Charge the Battery
1. Unpack the handset, battery pack, and battery
cover. If the battery cover is already on the
handset, press in on the notch and slide the
cover down and off.
2. Line up the battery pack connector
with the jack inside the handset.
(The battery connector will only fit
one way.)
3. Push the battery pack connector in
until it clicks into place. Tug gently
on the wires to make sure the
battery pack is securely connected.
4. Place the cover over the battery
compartment and
slide it up into
place.
5. Connect the AC adapter to the
charger's
AC IN 8V jack and set the
plug into the notch as shown. (This
adapter might already be connected.)
6. Plug the other end of the adapter into
a standard 120V AC power outlet.
7. Place the handset in the charger with
the display facing forward. The
ChArge light should turn on.
If... Try...
the
ChArge
light does not
turn on
xreseating the handset.
xchecking the AC adapter connection.
xseeing if the outlet is controlled by a wall
switch.
#
Charge the handset completely (about 15 hours)
before using it.
Red
Black